Posted by NCWayne on October 31, 2015 at 12:59:15 from (173.188.169.54):
In Reply to: Mechanical skils posted by Dan in Ohio on October 31, 2015 at 09:21:37:
I've been repairing equipment, welding, designing/fabricating, machining, and doing anything else I needed for over 25 years. I worked for others until I was about 32, then I worked for/with my Dad for about 10 more, and have been completely on for 6 going on 7 years now.
I stay busy as heck, and my customers think I can fix anything. Personally I don't think it's rocket science, especially if you have the ability to read a service book, and apply the knowledge gained from it into the work being done, as well as future, similar jobs. Like a man told me once, "There are only so many kinds of parts, it just depends on how you put them together, as to what they do....." Looking at things like that simplifies mechanics tremendously.
Now I can also do electrical work pretty good, but get into electronics, and computers, and I'm not completely dumb, but lets just say it's just not my thing.....LOL
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
