Posted by 2underage on November 19, 2015 at 05:35:01 from (64.19.81.242):
I had a good harvest season with no breakdowns on my JD 6620 combine and all was going very well until I stared plowing. First I plowed about 20 acres of sod without any problems and then I started to plow down corn stalks on a combined field. Plowed the first 15 acres without any problems and started on the next field when trouble began. The corn stalks began plugging the plow every few feet even though it had not plugged on the first field.
I looked the plow over and found that one of the shares had been bent and one of them had a broken point. Must have hooked a rock on my last pass on the previous field. So what to do?
No problem, I had a plow already mounted on another tractor so I just used that one. Again no plugging and I had nearly finished plowing, in fact I was making my last pass, when, bang, one of the front wheels suddenly fell of the tractor and I was done.
We had been having trouble with that wheel in the past and it had been repaired before and it showed no sign of distress but apparently the replacement studs had become fatigued and simply snapped when making a sharp turn.
My point, enjoy the good times when everything works as it should but be aware that sooner or later things are going to take a turn for the worse. I am going to fix the tractor right this time, looks like a new hub, and hope for a return of my good luck. Happy farming
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
