Greg1959, I doubt I'll ever see my deposit back, we've been nose to nose over some problems and happy he never called the police. Being the guy he is, and his reputation follows, nobody can believe we're still there. Also nobody within 40 miles will come out and do anything. Another episode is when the AC unit kept loosing the freon, he told me I was keeping it to cool in the house at 72 and need it at 78 since that what his is at. I'm 44 now and he is 81. So with the AC freezing up then thawing and running down the furnace over the circuit board, the local guy comes out and replaces the circuit board with the wrong one causing the ignitor to burn out every month. I'm tired of coming to a cold house so call a different guy that had a heck of a time with the factory trying to figure out the board and furnace. They sent a $500 bill to landlord and boy was he mad, I told him the furnace is fixed and take the bill to the local guy who screwed it up in the first place, been over 5 years and not a problem with the furnace. 15 years and still looking for a place.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
