Posted by paul on December 14, 2015 at 11:28:14 from (70.197.194.196):
In Reply to: Re: OT - Leasing Land posted by rrlund on December 14, 2015 at 10:28:33:
I mow perhaps 2 acres of my neighbors pasture. He doesn't run cattle for decades, fence got too bad, and this 2 acres is cut off from his property by ditch and broken fence. I think the county sent him a letter about controlling the thistles in it. See wasn't me complaining about it, I have my own issues..... Anyhow after 6 years of making hay the thisles actually are disappearing, don't see many.
I offered to cut another 3 acres next to it this fall, it hasn't been cut in a decade or more. I said it would not be worth anything, but get some weeds and such knocked down for them.
Wow, that 3 acres was rough. Didnt tip anything, but the mower spring the safety latch several times on gopher mounds, and was real hard feeding my hay basket, several busted bales as the baler and wagon lost altitude to each other. Had to drive slow raking.
Wish that was smoother ground, it would end up nice hay. But, would take some real dirt work and replanting to get there, not worth it for my deal nor for him....
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
