Posted by Bryce Frazier on December 20, 2015 at 12:45:13 from (67.142.182.23):
Made myself a set of chains for my K1500 yesterday.
I had an extra set laying in the weeds that came on an 8N. They started out being semi truck chains, for a single 22.5 tire. THEN someone did a real "nice" job of adding onto them so they would fit on the Ford.
I just cut them back shorter again so that they would fit on my truck if I needed them.
Now, i KNOW what these things are, there are 3 of them per chain, and go on the OUTSIDE of the wheel. They look like half moons, and are for tightening the chains after you put them on. Very handy, I have used them before on log trucks.
I needed to know what the tool looks like that works with them though?! I don't have one, and either need to buy one, make one, or find something that works "good enough"...
The hole that it fits in is like a rectangle, but is rounded like an oval. Anyone know what I am talking about?! ;P
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.