Posted by Leroy on December 25, 2015 at 07:12:54 from (69.88.202.68):
In Reply to: Tractor Shed. posted by L.Fure on December 25, 2015 at 06:41:52:
I have never been around any so do not know if this would be a concern or not. All information given is for length so I have no idea what width they are but I would guess they have to be legal width on the roads and that is eight and a half feet. Now take off a half foot on each side for the walls you are down to seven and a half feet to get the tractor in. I do not know what model B you have but some have extra lond axles and depending on how your wheels are set even with the regular axles it may not be possible to get it in due to the total width and then if you can I am sure that the only way to get to the end that went in first would be to craul over the tractor to get in or out. Now if they are only ment for rail or barge shippment then the width might be wider and alow the clearance you need for the wheels-axles that a 10' wide unit would allow but you probably would have to craul over the tractor to get to first end in. That means that if you drove it in that even to put gas in you would have to craul over the tractor to do it. Now if it was something like the N series Fords the 8 1/2" could work but still be tight. Have no idea what else you might want to put in But like other poster said set 2 side by side and roof over for your tractor storage and use container for storage of other things or use one for a secure locable shop.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - 12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.