I worked in a shop for 12 years, and got burned out to the point I had to do something else. I took my work very seriously, and tried to do an excellent job. But it turned out that I took myself and the job too seriously. It was very difficult to please both the boss, and the customer. When I was offered the "position" of shop foreman by age 30, I had already decided to move on. That was the mid 80's. I quit, and started into the only other thing that I was familiar with, or had a chance at- crop farming! Remember commodity prices in that era? That was 30 years ago, and a tough haul. I have built, at least in part, two houses, several barns, and several grain bins. I have moved/reinstalled three dump/grain bodies on trucks. I bought, fixed, overhauled, and successfully used lots of machinery. That's all history now. The last few years, I've actually had some money! And it's a good thing, because the days of me climbing around on a building, or in a piece of machinery, are gone. I have two good friends, who are not close by, and are busy, but are excellent mechanics. They helped me out two years ago when my combine engine ventilated itself at the start of corn harvest. Otherwise, I hope to keep my repairs on the small side any more. I have hired a few things done. But as you indicate, it's tough to watch, and pay out a lot of money, for marginal work.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
