Posted by Tom in TN on January 06, 2016 at 18:16:17 from (70.210.50.107):
In Reply to: Re: cattle trailer posted by MikeinKy on January 06, 2016 at 17:13:04:
Mike,
I rent a 16 foot Delta bumper-pull from the local Co-Op when I haul cows or calves. A couple of months ago I took two big black Angus cows to the sale barn - one on each side of the center cut gate. Those idiots managed to lift the cut gate off its hinges and caused all kinds of trouble for them. One of the cows was stuck under the cut gate. I got the situation resolved with the help of two other men. The problem with the cut gate is that it sits on three hinge pins, all of which point up with no restraint on the top of any of them. Now, when I use the trailer, I tie the top of the cut gate to a lower attachment point on the trailer to try to make it harder for the cows to lift it.
Other than that, I've using the Co-Op's Delta trailers for about 15 years with no other problems.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
