I solved my problem which was similar to yours. I used a stud finder to locate places that would accept blown in insulation. My method was to use a hole cutter to create holes in the walls from the inside. I then blew insulation in the walls where it was indicated. I am very pleased with the results. I saved the plugs that I cut from the walls and used dry wall paste to insert them back into the wall to plug the openings and restore the walls. When we were finished it was impossible to tell where the holes had been cut.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Using Your Tractor: Creating a Seed Bed - by Chris Pratt. When I bought my first old tractor, I had only one idea in mind. It wasn't the preservation of old iron since at that time, I was unaware that people even did this. It wasn't to show off my restoration skills (though I had tried my hand at a couple of old motorcycles in my teens and if I recall correctly, those old motorcycles were sold in boxes about one quarter finished). It wasn't to relive memories of Grampa, Dad or myself out on the back 40 nursing the Farmall pulling too many b
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
