Posted by Andy Martin on January 10, 2016 at 18:02:18 from (209.213.149.120):
In Reply to: electrical question posted by ben brown on January 10, 2016 at 09:09:55:
How much HP? I run my 3 HP mill on a 5 HP home made phase converter. It is incredibly easy, mount a 3 phase motor the same or larger than the lathe motor on the floor next tot he lathe. Run your single phase to two of the three leads on the converter motor, then run three leads from those three leads to the three phase power connection on the lathe. When you get ready to use the lathe, you engage power to the converter and, in my case, kick start the converter motor. It will sit and run and you can start and reverse the lathe so long as the converter is running. I can usually get a small three phase motor for free, it will have a cracked bell housing or broken foot, but still idle like a champ. John T could tell you how to wire up a push button capacitor to kick the converter motor over but I foot kick mine and don't need the extra wire.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Lifetime of Farm Machinery - by Joe Michaels. I am a mechanical engineer by profession, specializing in powerplant work. I worked as a machinist and engine erector, with time spent overseas. I have always had a love for machinery, and an appreciation for farming and farm machinery. I was born and raised in Brooklyn, New York. Not a place one would associate with farms or farm machinery. I credit my parents for instilling a lot of good values, a respect for learning, a knowledge of various skills and a little knowledge of farming in me, amo
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.