Posted by Bob Bancroft on January 18, 2016 at 05:23:47 from (67.142.162.23):
In Reply to: driving at night posted by Mtractor on January 17, 2016 at 19:45:56:
61 in the spring. I go to the eye doctor every 6 months because of glaucoma. I don't really have high eye pressure, but have slight damage anyhow. He says he may just see the start of cataracts. Around Christmas I did a bunch of high speed, heavy traffic, night driving on I-81 and 77 around NC and VA. When on the interstate, without the bright lights coming right at me, it's no problem.
A younger friend was just talking about having real problems driving at night. The doctor he saw said he might be a candidate for laser surgery. I have no idea what that has to do with it, and they didn't explain it to him either, at least not so he could repeat it!
A pet peeve I have is all the vehicles driving around with four headlights on. I have a vehicle with those low, extra lights, and I don't use them, as I don't see that they do anything for me in normal conditions. And I don't care to blind any oncoming drivers!
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
1945 Farmall wide body gas with pto and front plow. Runs good but needs new points.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
