Posted by Geo-TH,In on January 23, 2016 at 09:49:56 from (172.78.51.213):
I had three hydraulic cylinders decided to leak just sitting in cold pole barn. I'm thinking it may be a cold weather shrinkage problem, O-rings shrank. One of the cylinders was difficult to get apart. Someone had turned the end too far and pulled the wire all the way inside. I drilled the hole out a little larger, then used a smaller bit and drilled the backside of wire so when I turned the end, the wire decided to come out, THANK GOD!
I made a spanner tool using an old plumbing wrench. I also use a brake hone to clean up the end of cylinder. I find it easier to leave cylinder on tractor, saves removing hoses, just pull the rod and piston out.
I've concluded, if a hydraulic cylinder doesn't leak today, just wait it will leak tomorrow. I think I've rebuilt atleast a dozen so far.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
