Posted by Blueboy on January 23, 2016 at 15:50:32 from (67.20.251.27):
Apparently there are no bubbles, it was/is fuel agitation.
I talked to Ervin at Leid Diesel, he said that's what it looked like (Emailed the video). Also to hold the hose end below the surface of the fuel in a bucket to be sure. Last time I did that was with the bad injector and there was definitely bubbles.
After checking the fuel the engine was at running temp, I checked the valves and the gap was .027-.028, .001-.002 bigger from being set cold. The injector was 1.497, .001 over the cold setting. That was on the #1 cylinder, I didn’t see any need to go further or to make any adjustments. And I noticed the compression was much higher when I was turning the engine by hand. When I set everything cold it was a lot easer to turn. Which means the overall compression should be higher. Also the exhaust manifold temperature on each cylinder is within 5* of each other. Wonder how this machine goes in the snow…
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
