1) ditch the 6011 and 6013. Both have abysmal mechanical properties plus low deposition rates and no one in industry uses them anymore, just old folks who grew up with them (sorry)
2) Acquire some 7018 from tractor supply. The Hobart variety they have is usable, MUCH better than the lincoln sold at Home Depot which are honestly the worst electrodes I've ever run. Bonus points if you go to a real welding supply store and buy some Lincoln Excalibur 7018, you can get it 10 pounds at a time and its considered by many to be the best 7018 on the market. You'll have better mechanical properties, deeper penetration, easier to remove slag, a more controllable puddle, less slag entrapment issues, and a higher travel speed than the farmer rods listed above.
3) Set your machine to 90 amps if you bought the 3/32" rods, those are great for 1/8" and 3/16" steel. 3/16 and up you'll want 1/8" rods, which run around 120ish amps or a little more if you're using them in the flat/horizontal position but never above 140.
4) Watch some of the tutorials on YouTube to teach yourself stick welding. Yes, some of the videos have me in them.
There ya go, that's a synopsis I'll give after going through one of the best trade schools in the world and leaving among the top of the class with 5 certifications. In this day and age, 7018 or go home. It has a bit of a learning curve, but trust me you wont go back. Good luck!
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
