My co-workers were fishing in the St Lawrence around the Saunders Generating Station. They were following the school of fish around with the fish finder for an hour or two. Eventually they wandered a few feet onto the US side.
The American authorities came roaring out yelling and screaming while waving guns . As if they were fending off an all out invasion and in the process saving 10,000's of Anerican lives from death, disease and slavery.
We didn't think a 6lb walleye fish was worth that much fuss. And wondered how they ignore the border area with the native reservations, adjacent on both sides of the river.
It was wasn't much better on the Saunders Generating Station either . Start working on a unit down towards the middle where the border is and security has eyes and cameras on you by the dozen. If you walk around a cart , materials or are pulling on a rope and get near the line . They guards must be some awful bored since being discharged from active live combat in the Middle East . The US guards outright freak and are just about ready to shoot first and ask questions later . On somebody they have watched work around the place for years.
On the Canadian side the guards ask how your day is going and what the fishing was like on your day off. Then they pass the box of TimBits over to you to share.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
