Posted by The tractor vet on February 15, 2016 at 08:12:51 from (104.179.81.68):
In Reply to: Ratchet strap storage posted by Doug-Iowa on February 15, 2016 at 06:54:58:
The best way i have found for them is to roll them up and make them as tight as you can and place them in milk crates. and keep them in a DRY place. while i was on the road doing the big wide ugly hauling i carried 30 straps and ratchets that were longer then what you would normally find since some loads could be 12 wide and 13 high plus the tail . and some of the ratchets had long tails on them , so it was vary important to keep them all nice and neat as possible , same way with tarp straps i would make bundles of them in groups of 25 and wrap each group with a long strap and TIE it and hang it and add a second one pulling down carried 8 bundles of tarp straps and two full boxes of new. Thirty chains and binders So you learned to be neat and organised Had the milk crate in different colors red for the super long straps and blue for the standards . It made it easier for me when loading and that way i knew what crate of straps i needed for that load. . some of the big riggers had fancy strap winders that they could hook into a stake pocket and just turn the crank and wined up there straps , my trailer did not have stake pockets so it was done by hand .
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - 12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.