Good one Mark! I love that movie, went to see it about 5 times when it came out!
Reminds me of an incident that happened about the time that movie came out...
Lake Worth TX, Jacksboro Highway, a notorious stretch of road, low bottom honky-tonks, tote the note car lots, liquor stores, and no shortage of fitting patrons!
Late one night a car stops in front of a bar called "Inez 50-50 Club. (The running joke was "you had a 50-50 chance of coming out alive" LOL). He sits outside blowing his horn until several people came out to see what the commotion was. He yells out the window "Hey ya'll, watch this!"
He makes a full throttle, gravel slinging, curb jumping run, diagonal across the busy intersection, directly across K Mart parking lot, and crashes full speed through the front doors of the store!
He made it all the way to the back of the store before so much stuff balled up under the car it wouldn't go any further!
The store was closed, but there were stockers and janitorial crews inside. No one was hurt, but since people were in there, he was charged with attempted murder, along with DUI, (imagine that)!
What a moment of glory! Made some Mama really proud of her boy!
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
