Potential is any (and I mean any) difference in electrical charge between any two objects. This means there is almost always potential between things that are insulated from one another. Static electricity is excess electrons (or too few electrons) in an insulator (non-conductive substance). When conductors are in the presence of moving or changing magnetic fields, they gain potential. Conductors hooked to a supply of electricity (REMC or Con Ed.) they have a rated potential and if they are in good shape, will conduct that voltage to where it is needed. They can also have additional voltage (potential) induced into them in addition. Faulty grounding rods, or rods in dry ground, can fail to control the ground state of the ground wires, and the ground state of the neutral wires in that system (bonded to the ground at the meter and or first panel. A barn lot with animals (usually without gum boots) stands in a bit of muck, and gets a drink from a electrically heated tub, there is likely some potential. If you had wet lips and your bare feet in earth ground mud you would be reluctant to sample the potential your self, especially after getting a few volts the last time you tried it. There are systems in place that rely entirely on the earth to be the return link to the generating plant. any time you see one wire on poles going across country, that is the case. The stray voltage in that situation must be easily found!!. Jim
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - 12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.