Posted by notjustair on February 19, 2016 at 21:00:14 from (70.195.8.216):
How many of you make your own catch pens and gates? Just curious.
It seems to be a dying art around here with the advent of those catch pens on wheels. They seem like the are just super thin walled gates (like the blue "economy" bale feeders) that I would cuss all put together. What happens if the bull beats the devil out of it? Does it still work? I would think that it wouldn't stack well in that cute little cart.
I make all of my catch pens/sorting pens out of oilfield pipe and make my own gates including hangers. I usually end up with lots of gates - you can never have too many as far as I am concerned. The four section catch pen at the pasture has 21 gates on it. I can't imagine paying for those if I wanted something just as stout as I built. I build it all because I am stingy and also because I can envision how it will all be used as I am putting it together. Currently I'm finishing a 29x40 addition to a catch pen. It will end up with 9 gates unless I decide I need more spur of the moment.
I did see a sorting pen the other day made from three metal highway divider rails. It looked indestructible but you would need a torch to make every cut. With the pipe at least I can use the chop saw.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
