Posted by caterpillar guy on February 25, 2016 at 19:08:34 from (75.134.166.18):
In Reply to: Bearings and belts posted by DeltaRed on February 25, 2016 at 07:06:56:
Detroit Ball Bearing used to be pretty good. I think they closed the one in Lansing MI. I find Motion Industries in Lansing to be not much good for things as they don't keep much stock and don't want to look very hard. I find D&D in Corunna to be pretty reasonable for most things mechanical for equipment. From car parts to farm. The both of them are very knowledgeable guys. The owner is also at the counter, and has forgot more than most parts guys will ever know. As for NAPA I won't grace their palce with my shadow. I ordered an oil pan for a pickup one time. I was gone in the truck thought it would be in when I got back. Nope sent it back. Told me after I got back that they only keep things a week and then send back. If they had told me when I ordered it I would have made arrangements to either have it picked up or to be there when I got back in.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
