Posted by kub6040 on February 28, 2016 at 18:48:32 from (69.29.111.128):
In Reply to: Buying a truck posted by John in La on February 28, 2016 at 06:28:00:
John I am in louisiana also and I agree with the electrician the 4.3 is the better of the two but it needs 4.10 rears in my opinion and the 4.8 the numbers aren't real unless you drive with your foot flat on the floor it won't pull a popcorn fart out of a crawfish hole . My choose would be in gm 6.2 then 5.3 and last 4.3 no others qualify as truck engines . I own a 2012 gmc with a 5.3 and a 2000 Toyota tundra with a 4.7 and can say the Toyota will pull and the gmc rides and drives, so figure what you will be doing and get what takes care of your needs . My wife drives a new Toyota tundra and I think it is far better than either of the older ones . If you want to drive up and check out my junk call me 318-542-0896, we will load a trailer and you can see what you like..
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: 1964 JD 2010 Dsl - Part 2 - by Jim Nielsen. Despite having to disassemble the majority of my John Deere 2010's diesel engine, I was still hopeful I could leave the engine-complete with crankshaft and camshaft-in the tractor. This would make the whole engine rebuild job much easier-and much less expensive! I soon found however, that the #4 conrod bearing had disintegrated, taking with it chunks of the crankshaft journal. As a resul
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
