Posted by Ian Beale on February 29, 2016 at 13:55:35 from (139.168.164.158):
In Reply to: Re: Another Old Truck posted by rusty6 on February 29, 2016 at 07:06:02:
Rusty
The original utes here were also modified sedans. We have the remains of a 1926 Dodge that has a flatbed where the rear seat used to be.
The production ones were started by Ford here in response to a farm wife's request for a vehicle that could "take her to church on Sunday and pigs to market on Monday".
https://en.wikipedia.org/wiki/Coup%C3%A9_utility
That original one is still mobile.
The current version is the Falcon utility, with a payload of up to about 1.2 tons. And the 250 cid six is now dohc, injected (turbo option) etc and a lot more powerful
http://www.ford.com.au/commercial/falcon-ute
Holden (local GM) has similar. And we had a line out of local Chrysler as well until about the early 1980's when Mitsubishi bought that operation). No more when local production of both ends soon.
So there is a "collectors double" possible - first and last Ford ute's made in Australia.
And I learned to drive on a 1954 flathead Ford truck.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
