Posted by Billy NY on February 29, 2016 at 20:24:22 from (104.228.35.235):
In Reply to: 3 Pnt. Carry All posted by bradyw on February 29, 2016 at 16:24:17:
Some may be a bit light for tasks you may want to do, but any are a handy tool. It was necessary for me to go heavier, and I lucked out with what I found that was also easily modified. I'm going to see about building a woven mesh firewood box, it may be feasible, we handle a perfect material for these at work, even if its a one of due to cost, I can drive in and park with it in my garage.
Seems to me a good set of used fork lift forks and a frame you weld up, with a 3 point hitch arrangement fitted, will make a really nice carry all, make a box that you can just set down. First thing I did with this set was haul all my tools and rigging to a neighboring tree job, set them down near the work area, then pulled away from the pallet, ready for use. Without a loader, these are quite useful for all kinds of things. I have a lighter set as well, much easier to move, 2nd hand agrisupply but just as useful.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
