Ok, Ok , Ill start this one! Several years ago, my brother, Pastor John invited me out to Iowa for the WHO tractor ride held in Spencer Iowa. We traded off riding his 49 Case SC through out the area for 3 days.. Well I was hooked, and picked up a 1955 Case 411. A year later, Fast fwd to Centerville Iowa, sponsored by WHO Radio. I proudly mounted my 411 and headed out with 475 of my new best friends for three days of country road riding. This is the part you wanted to hear about! Two hours into the ride, we had just finished a short stop for coffee and homemade deserts from the local Betty Crockers in the county. You know who they are! The peach cobblers that melt in your mouth. The cherry pies that make your belly ache if you eat too much ,and the fudge brownies that can only washed down with a hot cup of coffee. So on the road we go, only to find the axle clamp bolts loose. T Chuck Machinisthe left wheel scoots out about 12 "on the axle. Back to the rest spot to tighten the axle bolts. That's mine ,what's yours Chuck Machinist
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
