Posted by ericlb on March 08, 2016 at 09:06:02 from (67.142.173.22):
In Reply to: Gas storage posted by farmallmaniac on March 08, 2016 at 07:51:55:
the first question is how much fuel do you burn? say in a months time, if your a hobby farm operation, and your fuel consumption is something less than 20 or 30 gallons a week, your doing the best way now, you probably need to use more jugs at the same time, i do this now, [ filling 8, 5 gallon cans each time],i also have a 100 gallon tank and pump on a farm truck. the reason is epa requirements have changed for fuel storage tanks, used to be a overhead tank with filter and hose was the answer ,then the truck comes and fills it when you called, now you have to use a inspected and approved tank for fuel storage, it has to have an approved containment structure around it capable of holding the entire contents of the tank in a cement surround,in case of a leak , you have to get a permit in some areas to have the thing in the first place , if your burning several hundred gallons a month it may be worth the investment, im the first to agree gas cans are a pia, but there also much cheaper than all this for a operation using a relatively small amount of fuel, when i worked at a area gravel plant which made its own material, we had fuel tanks on the place, it was a all diesel operation, the tanks were 2, 5000 gallon units, looking like overkill, i added up the fuel usage, it wasnt overkill the plant was burning 900 gallons a day! for all operating engines combined , a hobby farm is a grey area, some take up 5 acres, some take up more than 500 acrea, your best choice really depends on how much fuel you burn in a given time
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.