Posted by fixerupper on March 16, 2016 at 11:23:09 from (100.42.83.79):
I have a Deere 960 field cultivator with a Deere mulcher or evener on the back. At the hinge point area in the linkage where the mulcher bolts to the cultivator frame there is a bolt with a round rubber bumper around it that acts as an upper and lower depth stop if you want to call that. This rubber bumper is basically a rubber wheel 2 1/2" in diameter and approximately 1 1/2" thick with a 1/2" hole in the center. One of these broke so I went to the Deere dealer for a replacement and the parts man knew right what I was talking about and went to the parts room. He came back out with a steel puck and said they are made out of steel now. This is a nicely machined steel puck 2 1/2" in diameter and an inch and a half thick with a 1/2" hole in it, just like the rubber one only steel and colored gold. The price tag was $50.00!!!!!!!!! I left it on the counter. Looks like something home made is going in it's place!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.