I have never been to a foot Doctor. Third Neurologist though. MRI and EMG tests is what pinpointed my problems. I was never bothered much with anxiety in anything. I go to one Doctor this afternoon and two different Doctors yet this month. I went years telling my family Doctor about my pain and weakness in my legs and he said it was arthritis and age. I had never told him about my little finger being numb as I figured it was from getting my hand in the combine years back. I heard one of the Doctors on TV saying if your little finger gets numb you need to see your Doctor right away. That was when my family Doctor set me up with a Neurologist. The Neurologist ordered the MRI and EMG and came up with the Neuropathy. The nerve damage now is bad enough that they say I will not get better and they will only do surgery if the pain gets to where I can not stand it. I have become used to the foot and leg tingling type pain to where I can ignore it. It does wake me up some in the night but I get up and pee and go back to sleep. The moving around seems to dampen the tingling so I can go back to sleep. The are calling mine a chronic condition. That is live with what you are dealt or the alternative.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
