Posted by CenTex Farmall on March 24, 2016 at 20:42:27 from (72.107.203.188):
In Reply to: I smell a Skunk posted by ditchwitch on March 24, 2016 at 18:34:11:
We have skunks all the time and I was going to say cat food or raw eggs or even egg shells. That said, I hardly bother with them unless there's several and then time to thin them out. Mostly they dig around and eat grub worms which is a good thing. They will get into chicken houses though which is a bad thing.
I came up on one last night. The flashlight caught it about 10 feet away. I hollered at it and it ran off.
I was working in my shop one night with the roll-up door open. I was facing toward the lights with my back toward the opening. I felt something brush against me and caught a glimpse of black fur and thought it was one of our two black cats.....Wrong! Once it curved more into view I jumped up realizing it was a poll-cat (as Grandma called them). That sucker walked right by and brushed against me and into the shop like it lived there. When I jumped up it got a little spooked and hid under some shelves. Took me a good half hour to shoo it out of the building without getting sprayed.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
