Posted by andy r on April 04, 2016 at 21:36:11 from (75.91.149.15):
Last fall a contractor started on a series of push - up terraces. The topsoil was pushed to the side and clay was used to build the terraces. The topsoil was then pushed back. The majority of three terraces went through the winter and froze out. About 1/3 of the total footage was finished mid March. The areas that were done in November/December are so soft you can hardly drive a tractor across without sinking in 6 inches and traction is limited. In the fall constructed areas there were a couple places that looked like there was a broken tile (water coming to the top). There were no tile there to break. All of the work that was done this spring is normal - not soft and spongy.
My guess is that the topsoil that was pushed back was so loose it soaked up all of the water like a sponge compared to non - tilled ground. Just more water in it. Secondly I am guessing that the loose topsoil isn't transferring water to the compacted clay below as it would normally. Also the clay area under the topsoil would have been compacted by the dozer tracks and blade a great deal. Fortunately this field goes into soybeans. Just wondering what I should do. I think I might subsoil the area at an angle downhill towards the new tile lines. I think I can get through it by pulling it downhill. Maybe I would wait a day and chisel plow it lightly followed by the field cultivator in a day or two. It is almost like it needs a good packing. I haven't gotten much rain this spring, so maybe it just hasn't settled like it should. Thanks for your ideas.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - 12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.