Posted by HeavyHutch on April 08, 2016 at 10:33:15 from (166.137.126.21):
Recently purchased a 1942 Farmall H distillate model with 5000 ft altitude option to till ten acres of family property to plant in various vegetables for a market garden. The tractor had a miss at idle, which turns out to be the very low compression of 60 psi on all cylinders. Ran the valve lash and also found the #3 exhaust valve was at darn near .200" causing the correlating piston to be pitted badly. Anyway, it has become extremely hard to start lately and it's time for an end frame overhaul and need to know if a set of gas fire crater or step head piston will clear the distillate head? The Pistons that are in it are step heads, but was unclear if their was a difference between the distillate and gas step head piston heights. I'm trying to get the compression ratio up as this will be a working tractor pulling a 2 bottom plow, 8 foot tandem disk, and various cultivating implements. Any help is appreciated and thanks in advance.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Show Coverage: Journey to Ankeny - by Cindy Ladage. We left Illinois on the first day of July and headed north and west for Ankeny, Iowa. Minus two kids, we traveled light with only the youngest in tow. As long as a pool was at the end of our destination she was easy to please unlike the other two who have a multitude of requirements to travel with mom and dad. Amana Colonies served as a respite where we ate a family style lunch that sustained us with more food than could reasonably fit into our ample physiques. The show at Ankeny
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.