Posted by Kansas4010 on April 09, 2016 at 17:46:50 from (76.7.228.78):
Recently I was at Academy Sports and they had a Ruger LCRx 38 spl. with 3" bbl. This is the model with the hammer not the DAO version. I've not had the chance to handle one so I ask to see it. The first thing I notice is this gun is light. It felt like you were holding nothing at all. The second thing I notice is if I shook it very much at all it rattled like a tin roof in a hail storm. I was half expecting parts and pieces to fall out of it. The last thing I noticed was when they handed it to me they had the cylinder open. I closed it and rotated it till it locked, or so I thought. With just slight pressure from my thumb the cylinder would unlock and spin in the frame. The crane wouldn't open like for reloading but the cylinder acted like it wasn't locking up right. The young kid behind the counter tried to tell me that is normal. I told him I own several revolvers and none of them do that. I can see a gun like that being nice as a carry gun but does anyone else have one that acts like this one. I can't imagine Ruger allowing something like this. It's a shame because it fit my hand nice but if this is normal I wouldn't take it home as a gift.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
