I'm not sure I understand the round vs square corners, but if I do, square would be better in any way I can come up with that you mean that?!?! Especially of you are planting 6 and harvesting 4. You want all rows parallel as much as you can beyond any other goal.
Point rows you just plant overlapping into the headlands, all you can do. Don't leave a big gap unplanted, that creates weeds. Your combine header will get most of the extra plants.
You want at least 3 passes for the headlands. Its nicer making 4, as its 2 full rounds. Either way, won't matter much, whatever works for you. But at least 3, for the combine. The sprayer isn't much concern at all.
The last round where the rows meet, I will let one row double plant. When I get close enough for 2 rows to double plant, I go and flip the latch under the boxes to shift off those rows. No need to take the box off, just shut the row off.
One row overlapping isn't a big deal. 2 or more is wasting seed, but I'm a frugal (eh, cheap...) fella.
Paul
(Ha, it wouldn't accept my message, I had to read it real careful before I noticed how I had misspelled the word shift and made it unacceptable!)
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
