Posted by Bob on April 11, 2016 at 21:09:32 from (64.255.159.192):
In Reply to: Re: Water Pump posted by jerrodlk on April 11, 2016 at 15:45:56:
A service manual sure would be helpful!
I have OH'ed lots of waterpumps in my time but never one of these, so don't take my thoughts as "gospel"!
In general, you would carefully support the casting in a press with the impeller "up" and use a pusher of appropriate size and press downward on the SHAFT. Measure (with a feeler gauge) the gap between the impeller and the casting so it can be put back together with the same gap.
As the unit bearing moves downward out of the casting, the impeller will come up against the casting and stop and you can continue to press the shaft and bearing downward and out of the impeller and main casting.
(Before trying this look for a snap ring or wire clip of some sort keying the unit bearing to the casting. I don't THINK this pump is set up like that, but better look before breaking something!)
Once it's apart, the pulley or pulley mounting hub can be pulled off. Note it's position, as well, so it can be pressed on the shaft of the new unit bearing so that the distance relationship between the sheave and the pump body casting is the same upon reassembly.
Clean things up, HOPEFULLY the kit will come with some instructions, press the unit bearing into the casting to the same depth as the original, and install the seal following instructions (HOPEFULLY) provided. Use an appropriate sleeve/pusher to press on the outer bearing shell, and NOT on the shaft, which would apply stress to the bearings.
Once that's done, press the pulley/hub onto the shaft to the previously measure location, and the same with the impeller.
When doing this, support one end of the shaft or another so no side load is placed on the bearings.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Lifetime of Farm Machinery - by Joe Michaels. I am a mechanical engineer by profession, specializing in powerplant work. I worked as a machinist and engine erector, with time spent overseas. I have always had a love for machinery, and an appreciation for farming and farm machinery. I was born and raised in Brooklyn, New York. Not a place one would associate with farms or farm machinery. I credit my parents for instilling a lot of good values, a respect for learning, a knowledge of various skills and a little knowledge of farming in me, amo
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.