Posted by JMOR on April 21, 2016 at 10:17:52 from (76.182.223.85):
In Reply to: Unknown rotary cutter posted by Roger in Wisconsin on April 21, 2016 at 06:55:28:
Quoting Removed, click Modern View to seeWell, certainly you never want to turn short to the extent that you exceed the joint's operating limits, but with incorrect hitch/u-joint geometry, that "limit" is very small! Unless there is something I can't see in that picture, that geometry will place the angle of the tractor end joint at a far different angle than the hog-end joint in ANY turn and that is Wrong. To keep angles equal, the hitch point needs to be half way between the tractor & implement joints. For those two pieces of equipment, that means that it needs a carrier bearing far forward on hog tongue with another shaft and joints. Otherwise those different angles will result in acceleration/deceleration cycles on every revolution that the operator feels & hears as "chatter". It will be present at any angle other than zero & get worse with greater angles. Correct geometry will eliminate the problem, within the design limits of the u-joints, when angles are equal.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
