Posted by DeltaRed on May 10, 2016 at 22:15:32 from (65.100.144.48):
In Reply to: DeltaRed posted by Cliff Nelson on May 10, 2016 at 21:31:45:
Wear parts I Can buy at our local Coop. The local hardware store(OlatheTrue Value) also sells plow parts.In IH dealer in furrow irrigated country will probably stock them.Nice thing about IH plows is they didn't change much. An old #314 uses the same parts as the newer ArtsWay plows.Contact Wiese or Adams ,they make wear parts for plows.Any Equipment dealer should be able to order some.As far as usedParts?Only place I know would be MuthWelding,and Muth Farm Equipment.AllenGoodman who posts here from time to time runs the place.Both are in RockyFord,Co. You have a bent beam? I have acctually 'fixed' one.Was bent badly. I cut it at thge bent place.Ground it out...Then bolted it to a good beamfrom the oppisite side Welded the deep groove,chipping the slag after each pass. Let it cool while bolted solid. Then 'finished' it(filled any 'divots and ground smooth)It is straight as a new one and is on my plow as we speak. I also have about 5 complete rigid beams and standards(both sides) out back on a pallet that I would sell some of.I also have most of a 642 and part of a 314 out back for parts aswell.That Rigid beam will fit several IH plows(210,314,642 and some one way plows as well.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - 12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
