Posted by Adirondack case guy on May 14, 2016 at 16:30:21 from (74.69.160.79):
Kinda forgot what I posted last. Since we got the rebuilt engine running, I have been fabricating again. The factory cab only had a LH door, but it now also has a RH door and I fabed up steps on both sides that and old fart like me can climb up and down to get in and out of the cab. I also designed and built a set of fenders for the front wheels. Hopeing the weather will warm up so my CBS paint booth warms up. (the same brand of booth that Big Tee uses)The roof started leaking again this afternoon. HeHe Anyway I have been pressure washing it and got the chasis about ready for paint. I removed the front and rear rims and tires today. The weather watchers are calling for snow fluries tomarrow, but I have lots of sheet metal to sand and prep for paint, that I can do in my shop. I also aquired another project a couple weeks back. a Case 830 that my dad ordered in for one of my uncles. I am preping it for paint also. It runs great and need no mechanical work. Just tires and cosmetics. Loren,the Acg.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Usin Your Implements: Bucket Loader - by Curtis Von Fange. Introduction: Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he rea
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
