Posted by fixerupper on May 20, 2016 at 11:16:36 from (100.42.83.79):
In Reply to: Got him again posted by rrlund on May 19, 2016 at 17:19:57:
When I was at the sale barn one time a bull calf in the ring darned near went over the ring corral and into the bleachers. even the old seasoned scalpers sitting in the second row were ready to get up and run. LOL. I was at the auction in Bassett Ne maybe thirty years ago. In the staging pen just outside the ring I saw the help all jump up on top of the corral gates right before they let this wild bull calf in the ring. The ring man was on a big cutting horse and he rode the horse into a protected stall on the edge of the ring for cases like this only the horse's rump was still exposed. The bull calf saw the horse's rump and rammed into the horse several times but the rider held the horse still while he calmly sat in the saddle with a cigarette hanging out of his mouth looking back at the action going on. About fifteen seconds later they opened the exit gate, the bull calf ran wide open out of the ring and the guys in back were jumping up on the corral panels again. I was amazed at how well trained the cutting horse was. It was about four times bigger than the calf and could have kicked the calf senseless but it held it's ground.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
