Posted by Geo-TH,In on May 21, 2016 at 04:47:20 from (172.78.124.73):
Albert Einstein, Said that the definition of insanity is doing the same thing over and over and expecting a different result.
I drive past a house covered with tarps. The other day they were removing the metal roof one sheet at a time and installing a new roof. The rafters and perlins looked black like my friends pole barn where he keeps his horses, black from water damage. My friends pole barn has nothing under the metal. Frost in the winter forms on the metal. Sun comes out, better run, it rains and smell like horse pee.
They weren't putting anything under the new metal. I saw no gable vents, roof vents, eve vents. Wonder is this guy has mold in his insulation. Please vote, Should this guy get the Albert Einstein award for insanity?
Shouldn't all attics be properly vented regardless if they are shingles or metal? I don't see too many roof vents on metal roofs, why?
I'm a believer you can't have too many much ventilation. My roofs have roof vents 10-15 ft apart, eve vents, some gable vents, ridge vents and power vents, which cuts down on A/C load. Shingles will curl if you don't have proper ventilation. Will metal rust on the bottom side without proper ventilation? Won't this guy have condensation issues like my Friend's pole barn? I'm not worried about my boat rusting, it's aluminum. geo.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
