Posted by RBoots on May 25, 2016 at 19:40:02 from (173.241.113.102):
In Reply to: Field cultivator posted by Farmall43 on May 25, 2016 at 16:05:21:
We do exactly as Dave says. Try to chisel all or as much as we can in the fall. Our Glencoe soil saver has a short spike leveler on the back of it. Fall chiseling helps our fields dry out much faster in the spring and keeps the weeds from coming in as fast. Then, spring time rolls around, we run the Sunflower field cultivator over it, it has a 5 bar spike leveler, and plant it. Now in fields that got a bit grassy, or our stony fields, we use our smaller Wil-Rich field cultivator with no leveler, with a cultipacker behind it to flatten any clumps and push down any rocks. And when I say rocks, I mean ROCKS! We run a rock picker over the fields, but if we took all the rocks out, we'd have a low spot lol. We rarely use our disc anymore, once the stalks go through the soil saver, they are pretty much done. We have now started chopping our stalks with a flail, which can eliminate the need to chisel, but we still like to anyway just to help with spring drying. We could just run the field cultivator over it after chopping, but it doesn't dig as deep as the soil saver will. The rocks are pretty hard on the disc blades, so we just use the field cultivator to pull up the big ones, which we remove, then push the small ones back down.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
