Posted by Brendon-KS on May 25, 2016 at 22:22:12 from (206.225.246.20):
In Reply to: Field cultivator posted by Farmall43 on May 25, 2016 at 16:05:21:
From what I've observed the implements that are used all depend on where you're at. In areas where surface irrigation is used moldboard plowing and disking is still very common and in some areas, such as SE Colorado, field cultivators would be relatively uncommon. There they plow, disk a few times, then go over the ground with a leveler, often called a "float", to ensure that the water flows properly. I'm currently on a business trip in the Imperial Valley of California and haven't seen a field cultivator around yet but there are lots of disks, mostly heavy offset models. On the other hand, in Kansas wheat country a field cultivator is about the most-used implement that "tillage" farmers have. However, as was said by notjustair, field cultivators can become rakes when long, unbroken stalks like corn or milo residue is present. My father-in-law here in Kansas typically runs over stubble with a heavy disk then everything after that is with the field cultivator with 5-bar harrow attachment - it is the best implement around for killing weeds and smoothing the soil. When equipped with overlapping sweeps and run an inch or two deep there are virtually no weeds that can escape even a single pass.
Note that modern field cultivators have much more residue-handling abilities (noting the above limitations) than those made decades ago. Old-fashioned field cultivators with closely-spaced shanks were designed more for plowed ground where there was little residue on the surface. Newer ones are taller and have more rows of shanks to allow a wider spacing between adjacent sweeps while still maintaining complete, overlapping coverage.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
