Posted by oldtanker on May 26, 2016 at 10:36:53 from (66.228.255.59):
In Reply to: Moving rocks posted by JL Ray on May 26, 2016 at 10:14:47:
Measure the rocks you want to move: To estimate the quantity, you need to convert the area into cubic feet by multiplying length x width x height. Once you have this number, multiply it by the boulder's weight per cubic foot, then divide by 2000 to convert this number into tons.
Weights vary with type of rock.
Sandstone is about 150 pounds per cubic foot and limestone and granite about 175.
Your lifting device would have to be capable of lifting that weigh and transferring onto the trailer.
I dug out a couple of rocks for my BIL this spring. So using the above information:
One was about 10,000 pounds and the other about 12,600. one was about 4x4x4 and the other about 8x3x3. I was able to push one off the field with my backhoe and place it into my sisters flower bed the other we hooked onto with a chain and used their CaseIH 5250 MFW with me pushing with the backhoe.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.