Posted by oldtanker on May 29, 2016 at 09:43:58 from (66.228.255.59):
In Reply to: farmall m. help posted by Jasondeere on May 29, 2016 at 05:33:06:
Quoting Removed, click Modern View to see
No, it would burn up the coil. Points don't care about 6 or 12 volt they are only a switch to open and close a circuit.
I don't have the number but they do make a coil that will have printed on the body "12V no external resistor required".
For the OP. Trouble shoot before you start buying parts. You may fix it by throwing parts at it but most often will spend a lot more money than you have to.
Find an old plug. Gap it about 1/4 inch. Then run the tractor. As soon as it dies pull a plug wire and put the old pug in it and crank the engine over. No spark means and ignition problem. Good bright blue spark means it's most likely a fuel problem. As soon as you are done checking spark: Take container to catch gas in and disconnect the fuel line at the carb or if the carb has a drain plug on the bottom of the bowl remove the plug. Watch gas flow for about one minute. Should be a steady stream about the size of the fuel line. If from the line and flow is good then it's a carb problem. If from the bowl the system is good through the needle and seat but the problem is still in the carb itself.
A little advice here. When asking questions about these old tractors you should state 6 or 12 volt as many have been converted to 12 volt. It's helps when others are trying to help you figure out a problem.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Grain Threshing in the Early 40's - by Jerry D. Coleman. How many of you can sit there and say that you have plowed with a mule? Well I would say not many, but maybe a few. This story is about the day my Grandfather Brown (true name) decided along with my parents to purchase a new Ford tractor. It wasn't really new except to us. The year was about 1967 and my father found a good used Ford 601 tractor to use on the farm instead of "Bob", our old mule. Now my grandfather had had this mule since the mid 40's and he was getting some age on him. S
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
