Growing up, the convention in grape vineyards was a grape hoe- a grader blade like device that you maneuvered in and out under the trellis around each plant and post. Hoe the dirt and weeds away in spring/summer, then hoe to the plants in fall to protect the rootstock. The horse-drawn unit was long gone by the time I came around, we had a hydraulic unit mounted on our JD 1010, with a small lift disc behind to chop up the weeds. Very slow moving, so as to not damage plants or posts.
The use of herbicides began to replace the mechanical tillage, but not so much at our place. My Dad, a veteran of many hours of this half-row-per-pass cultivating, was always dreaming of a grape hoe with some kind of mechanical tiller on the end, rather than a blade. Imagine our excitement when I found out about the Weed Badger! A production model similar to a grape hoe with a hydraulic rotating head and sensors that moved it in and out automatically!. And there was a used one for sale nearby!
I bought it, and we spent good money having a mount made for our 2355N. Never imagined we did not have enough hydraulic flow to make this thing work- you could make it go in and out okay, OR make it rotate great, but not both at the same time. It would be fine for a little bit, then heat up and stop one of the motions, usually just in time to tear a plant out by the roots, or bend over a post. I'm pretty sure the last trial ended up damaging the hydraulic pump in the tractor, it has never quite been right ever since. The solution is a different tractor with more flow, or the PTO driven hydraulic pump setup from the manufacturer for a couple more grand. Our solution has been to shove it in the corner of the barn and stack other crap on top of it in shame.
Thanks for the opportunity to share my shame, hopefully my experiences will help you all avoid similar pain in the future. Step six of 144 step farm-fever healing process complete.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
