For many years, I used to stop to help people that were broken down. Over the last couple of decades, it has become too much hassle most of the time. The last few times I stopped to help:
One time, I stopped to help someone that had stalled out. Turned out that the fuel line had come off. This was a high pressure system, and a critical clip was missing. I told the driver to wait for me (I was close to home) while I got a clip and replaced it SAFELY. Upon my return, some know-it-all decided that he was going to be the "hero" and get the driver back on the road. I returned just in time to avert a catastrophe. KIA was going to jury rig the fuel line rather than repairing it SAFELY. I installed the correct clip and ended up arguing with KIA over the "quality" of the repair/
Another time, I stopped to help a young couple on my way to an auction. Right from the start, they treated me like I was Jack The Ripper, stopped to do them harm. I finally just left after a rather indignant lecture I gave them. Something like "I offered you the services of a PROFESSIONAL mechanic to get you on the road FOR FREE. You treated me like a criminal. I'm out of here. Good luck with your breakdown."
Seems like every time, there is some smart alek that has a short answer and an unsafe repair job. I mostly gave up. From this point forward, I just casually inquire as to what the problem is, and politely offer my services to help the "victim" to get back on the road. At the first sign of mistrust, I leave. When I offer my over 40 years of automotive experience for FREE, I do not expect to be treated like a red-headed stepchild.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
