They didn't start carding at the on base clubs until the late 80's early 90's when those rules went into effect. By that time the junior NCO club and the EM club had been combined into the NCOEM club. Senior NCO's were allowed/welcomed in the officers club after that. Those changes were largely due to the club playing politics running off soldier who then found places off base to party.
Muleboss: Lot of guys who served in the military joked about it being like doing time. After all, you don't have much say as to where you live plus on time off you are restricted in how far you can go off base. A civilian in NYC can hope on a plane Friday afternoon, fly to CA and return Sunday evening. A service member is generally not supposed to go more than 150 miles off base, 600 on long weekends. Not a job that you can give your 2 week notice either. You have restrictions put on what is some basic freedoms in the very Constitution and Amendments that you swear to protect and defend like your freedom of speech. It is a chargeable offence to say anything derogatory about the president and your officers and NCO's over you. Sure you can say you don't like them. You can say you don't think they do a good job. You cannot say they are a "draft dodging, gay loving, dope smoking, long haired, womanizing, indecisive wimp". Saying you don't like your Sgt is OK, calling him an idiot isn't. You are also committing an offence should you lie in line of duty. So if you lie about to a Sgt or officer when they ask you a question and they can prove it they can charge you. Plus any NCO or officer can order you to shut up, the correct command is "at ease" and it's an enforceable order.
So "I did my time" refers to both that and your time as a young man fulfilling a commitment to our country.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
