Posted by Adirondack case guy on June 11, 2016 at 07:21:25 from (74.69.160.79):
After 50 years of getting along with what we had, it was time for an update.One of our old evaporators started leaking badly and was beyond repair. We bought a newer more efficient one to replace both of them. We had to get the old evaporators out, remove all the old cracked cement floor,cable and jack the structure back to straight and level, and tare out and pour a new retaining wall where the building is built into the ledge. We made the first pour yesterday. 7.5yds to do the new floor. We had to do the floor before we could build and ancor forms for the knee wall and slab where the 2 1000g storage tanks set.That will probably be at least a 7yd pour also. We pulled the windows out of the frount of the building and had the driver nose the chute in the windows so there wasn't any need for wheelbarrows. The redi-mix driver is a neighbor also. Fortunately we have all the toys to do work like this. Compact trackhoe, skidsteer, plate tampers, lazer guided power screed ,and power trowler, and the knowledge needed to get the job done Loren
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
1945 Farmall wide body gas with pto and front plow. Runs good but needs new points.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
