I think it turned out good in spite of having to moove at last minute to a different county fairgrounds. On sat we had a by the bucket downpoor that shut things down for a while. The consignment auction was way-way down and a few normal venders were not there but others that I have never seen were. Neighbor from accross the road that sells honey said his sales were down by a fourth but it so happens that the building we used yo have was a nice building with plenty of room, where things were in this year poor building with not enough room. Smaller grounds and was packed. The parking everybody had to be hauled in but used the multi seat limo golf carts and it worked out OK and they did not have to hit the streets with them at all as the parking was at the school but the lot was too far away to walk. But transportation was all on the school grounds. Have not yet found out how the gate reciepts were but I think they were good for first time in new place, And I hear some venders cannot read that had been there others and had signed contracts with them stating the move and location drove right past to old location only to find they had to turn around and go back to where they had went past. One thing that was better was the parking is all blacktop so with that rain there was no mud in parking lot area. What is feature at Winamac? Going to have your tent?
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
