Posted by avion mike on June 19, 2016 at 12:15:18 from (64.111.59.78):
In Reply to: 3 point question posted by Avion Mike on June 14, 2016 at 17:55:34:
Thanks everyone for the information. I have a set of the factory fast hitch prongs that someone has extended a couple of inches to around 17.5 from the PTO but my JD 2 bottom plow was just barely rubbing on PTO shield. I took the shield off to plow the garden last fall but wanted to do something different this year. I bought a J-hook type 3-point adapter and had some prongs made with them welded on top to get a little extra height on the fast hitch. I decided to go about 4.5 inches longer than the prongs I had. This ended up with the eyes on my lower lift arms about 22 inches away from the end of the PTO. Now that it is all welded together and painted, I wish I had only made them about 20 inches long because it just looks like they stick out too far. It handles the blade and brush hog nicely though so I probably will not cut it apart and redo it unless I have issues with it in the fall with the plow.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
