Posted by RayP(MI) on June 23, 2016 at 07:17:12 from (207.241.143.27):
(At a reasonable price, that is.) Have a arched roof barn, 35 feet from floor to bottom of rafters. I can reach light fixtures only by standing an extension ladder virtually straight up, and kind of wedging it between a couple rafters. As you can imagine, I don't want to do that very often. So looking into putting very bright LED bulbs in. There are three fixtures installed, the old ones where a 2 quart, widemouth mason jar screws over the bulb and into the fixture. Was installed about 1952 and has been fine.
Now here is the quandary: need something very bright, as am lighting a lot of empty space. Thinking 200 watt equivalent. We had good success with 200 watt conventional bulbs years ago. Last few times I replaced, it was with the biggest CFL bulbs, they have been a great disappointment. So on to LEDS. About the only thing I can find in most stores (home improvement, hardware,) is 100 watt equivalent. Then I tripped over 300 watters at my local ACE hardware at only $40 each. (Seemed a little steep, but If I don't have to replace in my lifetime...) They are FEIT brand, and in talking with my industrial electrician, he says that if I want to replace weekly to monthly, go for it. So I asked his favorite vendor, said GRAINGER. Man, now those guys have precious LED bulbs!
Anyone got a place I can get good, inexpensive, dependable, high performance long lifed LED bulbs?
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
