Posted by JD Seller on June 25, 2016 at 18:45:33 from (208.126.198.123):
In Reply to: JD Guru hyd pump 2640 posted by nhbalerman on June 25, 2016 at 13:00:14:
I hate to say it but your going to have to re-split the tractor. You either cut an oring, crushed a tube/line, the transmission pump is sucking air, maybe the transmission pump is broken again. I had one that had a bad bearing behind the transmission pump that allowed the shaft to drift back and forth just a little bit. It broke a gear in the new pump I just installed.
Also did you remove the suction screen in the bottom of the rear end housing???? You could have other issues deeper in the transmission than just the broken charge pump gear.
Getting all the lines and orings together without damaging one can be a challenge on these tractors.
PS I just had a thought. Take the gear shift housing off again and blow air down through the two larger lines. See if you can hear a leak some where.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Cautionary Tale - by Ian Minshull. In the early 1950s my father bought an Allis Chalmers B and I used it for all the row crop work with the mangolds and potatoes, rolling and the haymaking on our farm. The farm and the Allis were sold and I have spent a lifetime working on farms throughout the country. I promised myself that one day I would own an Allis. That time event
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
